Jump to content

The thing I use to move my sled pics (formerly dollie pics)


AkronOrange

Recommended Posts

Some folks from another thread wanted some pics of my dollie.

1. Lag 2 pieces of 2x8 together, the lengths are dependent on the sled.

2. Mount 4 swivel casters in the corners. One under each ski, the 2 close to the back. One can be placed in the center (or centre) for additional support.

3. The "Run Over Cat Flap is Optional"

dollystanding.jpg

Place the long end under the sled and then drive on and drive off. It takes some getting used to. When driving off, be sure to point the back of your sled ay the nearest Yamaha, then let her rip!

gettingstarted.jpg

Use the emergency brake when moving the sled when it is on the dollie. It is difficult moving the sled on the dollie through the snow. It works very well on the concrete floor.

Fonton.jpg

Backon.jpg

Onthedolly.jpg

Link to comment
Share on other sites

Do NOT make a posting by this name it causes the mouse to injure himself :whatever:

My bad! Is that better?

Link to comment
Share on other sites

Very cool! And at a fraction of the cost of that commercially made jobbie. Would it be worth adding a section of old track to the spine of that dollie?

Looks like a good Summer project to manufacture a couple of them.

Link to comment
Share on other sites

Nice simple design! I like it!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...